Fuel pump relay is located on the front of the trunk. Turn ignition to the start position. When the engine starts, proceed to the next step. If the engine does not start, go PUMP to FUEL resistance (3.5RL).) 2. Turn engine off and ignition on. Measure the voltage between ground and PCM-12-pin connector terminal No. 4 (green wire).
If battery voltage is present, go to the next step. (If the battery voltage is not present, go to step 4). 3. Engine start, and at 3000 rpm with no loads and transmission in Park or neutral, comes on to the cooler fan. Allow engine idle for at least a minute. Engine switch off. Vacuum manifold disconnect vacuum hose no. 21 are you 8-12 in. Hg (27-40 kPa) vacuum manifold absolute pressure (MAP) sensor. Start engine and run at 6500 rpm with no loads and transmission in Park or neutral. Measure the voltage between ground and PCM-12-pin connector terminal No. 4 (green wire).
Advertisement:
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.