Refer to Lifting and Jacking the Vehicle ( See: Maintenance\Vehicle Lifting\Service and Repair ). 2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation ( See: Maintenance\Wheels and Tires\Service and Repair ). 3. Remove the left outer tie rod from the steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (All Wheel Drive) ( See: Steering and Suspension\Steering\Tie Rod\Service and Repair\Steering Linkage Outer Tie Rod Replacement )Steering Linkage Outer Tie Rod Replacement (Rear Wheel Drive)
( See: Steering and Suspension\Steering\Tie Rod\Service and Repair\Steering Linkage Outer Tie Rod Replacement ). 1. Install the new O-ring (2) on the intermediate shaft. 2. Install the new retaining ring (1) on the intermediate shaft. 3. Apply a small amount of grease GM P/N 01051344 (Canadian P/N 993037) or equivalent to the intermediate wheel drive shaft splines. 4. Install the left front wheel drive shaft in the intermediate shaft. 5. To ensure that the wheel drive shaft is installed properly, grasp the inner tripod housing and pulling it outward. DO NOT pull on the axle shaft . 6. Install the wheel drive shaft in the front knuckle. 7. Install the left upper control arm on the knuckle. Refer to Upper Control Arm Replacement ( See: Steering and Suspension\Suspension\Control Arm\Service and Repair\Rear Suspension\Upper Control Arm Replacement
Advertisement:
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.