Note the rules for cleanliness. Attention: Note safety instructions disconnect the battery. Disconnect the battery ground (GND)-Gurt with the ignition switched off. Caution: Secure ground (GND) wire of the VAS5190 on an empty part of the chassis. Drag cone piece 2 shaft piece-1 - by VAS 5190. With electrical tape, apply a mark - arrow - on hose finally a = 1465 mm from the end of the suction hose.
Remove filler cap from the fuel filler tube screw shaft piece 1-VAS 5190 fuel suction next fuel of filler tube fuel tank. Slide hose now, how far into the fuel tank to the mark from earlier - arrow - stands on stem piece. Note: If a siphoning device without stalk pieces, above all in the same way in this case continue, apply a mark - arrow - on hose finally a = 1400 mm from the end of the suction hose with electrical tape. Suction hose pipe is correctly inserted, if the labelling is earlier compared to the lip of the fuel filler tube is applied. If the hose can be inserted with difficulty, smear it with thin oil. Never use lubricants with silicon. Drain the fuel tank through the fuel filler pipe. Gently remove the siphoning tube. : Remove sedan luggage compartment lining. If necessary, push the right back of the back seat. Avant: Remove links 1/3 backrest. Left to remove side trim in the luggage compartment and dirt tray.
All: Remove the cover for connection flange (arrows). Let and pull harness Connector 1-. To resolve the electrical harness plug-2 and you set it aside. Attention: Work on the fuel system must perform only, when the engine is cold. Fuel system is under pressure. Create system, rags, to connection area before opening. Separate fuel supply line 1 and fuel line 3 back (press release tab) and let then carefully to solve print by combining mark. Disconnect the ventilation Linie-2-(Pressemitteilung-Taste).
2004 Audi A4 1.8 L Turbo FWD L4-1 fuel pump remove and install guide Download
Advertisement:
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.